Surface electro-myography sensor for measuring raw SEMG on channels A-B of the ProComp Infiniti. The sensor is compatible with the triple electrodes (triodes) or with the interposable extender cables required for more distant electrode placements (e.g. in the face with small electrodes).

preamplified electro-cardiogramm (ECG) sensor which directly measures the elecric heart activity. Incudes ECG wristbands which allow to measure IBI (inter-beat interval) from ECG at the wrists, using a complex artefact removal algorithm in the process (offline). Requires additional ECG extender cable for electrode placement (plus the single use electrodes themselves)

Sensor marking - set with two clips each in 10 different colors and 3 documentation cards

Sensor cable - EXTRA SHORT 30 cm
EXTRA SHORT cable for sensor connection

Interface BNC Cable für Sensor Isolator

Pigtail Interface Cable für Sensor Isolator

Sync cable to connect 2 Infiniti systems via USB

Voltage Isolator: Enables integration of third-party sensors with Infinit encoders and BioGraph Infiniti software. The sensors must provide a signal within +/- 2000 mV (partial ranges are sufficient). This signal is then transferred from the encoder to the BioGraph Infiniti software for further processing with the wide range of on-screen instruments and calculation options. This is an extremely useful accessory, especially for research institutions, for integrating additional signals and sensors.

The Voltage Isolator 4 allows synchronous recording of measurement data that is not recorded by one of Thought Technology's sensors. Examples could be the intensity of audio signals (e.g. gastrointestinal sounds). With the Voltage Isolator 4, Thought Technology’s systems to be safely interfaced with analog outputs of line-powered systems, such as computers with DAC cards, isokinetic dynamometers (such as Biodex System), or force platforms.

velcrow replacement strip for temperature sensor (length: 10 cm)

Polar chest strap for connection to the BioGraph Infiniti software system.
Also requires the corresponding receiver (ECG receiver).

Befestigungsclip für EEG-Z Sensor

Colored insert cards to document with which color which sensor is marked.

Cable for sensor change / impedance check with ProComp 2

Sensor-Cable extra long (244cm)

EMG/Stim Cable For Use with MyOnyx - Portable and Wireless - EMG and Electrostimualation Devices

Connection cable for bridge and ear electrodes 2mm insulated plug /DIN for EEG55/5600-130cm

For positioning the electrodes